Magnavox MMA3626 - Portable Speaker with Bluetooth Manual

LOCATION OF CONTROLS

1. Built-in Microphone
2. Button
3. Button
4. Button
5. Button
6. LED Indicators
7. Micro USB Port (For charge only)
8. TF (Micro SD) Card Slot
9. USB Port
10. Power ON/OFF Switch
11. Flashlight

POWER SOURCE

The unit has a built in Li-ion rechargeable battery, recharge it before use or when the battery is drained as follows:

1. Connect the Micro USB Plug from the supplied USB Connection Cable to the Micro USB Port on the rear of unit.
2. Connect the full sized USB Plug from the supplied USB Connection Cable to the USB Port on Computer or USB Charger (Not included). Charging will automatically start.
   1. While charging, the Red Indicator on rear of unit will illuminate.
   2. While charging, you can also play and listen music at the same time.
      

Notes:

Your battery will last longer if you're following these simple guidelines for charging and storing.

1. Before first time use (or recharge it when the battery is drained), charge it approximately 3 hours.
2. Recharge and store the unit within the temperature range of 5°C~35°(40°F~95°F).
3. Do not charge longer than 24 hours. Excessive charging or running the unit until battery fully drains will damage battery. Battery life will be extended if you keep the battery fully charged.
4. Battery life naturally shortens slowly over time.
5. The rechargeable battery incorporated in this product is not user replaceable.

OPERATION

General Operation:

1. Recharged the built in Li-ion battery as previously instructed.
2. Slide the Power ON/OFF Switch to ON position to power on the unit. The Blue Indicator on the rear of unit will illuminate.
3. Press and hold the Button repeatedly to switch to desired playback mode. The unit will sound the prompt with your selection (see list below):

   Playback Mode:	Voice Prompt:
   BT (Bluetooth)	Bluetooth ready for connection
   TF (Micro SD) Card	Memory Card
   USB	USB

4. During playback, press and holding the or Buttons to adjust volume level as desired.
5. When finished listening, slide the POWER ON/OFF Button to OFF position to shut off the unit.

Flashlight:
In power on mode, press the Button to power on Flashlight, press again to shut it off.

BT Mode:
BT (Bluetooth) pairing:
First time use or re-pairing the unit to a new BT Device, pair as follows:

1. Power on the unit and enter to BT mode as previously instructed. The Blue Indicator on the rear of unit will illuminate and blink. The unit also will sound a prompt "Bluetooth ready for connection".
2. Power on the external BT Device and enter to BT searching mode. Start pairing following the on screen instructions from the external BT Device. When paired, the unit will sound a prompt "Bluetooth connected" and the Blue Indicator will stop blinking.
3. If pairing is complete you may now play music and answer calls with your external BT Device.
4. During playback:
   • Press the Button on the unit to pause, press again to resume normal playback.
   • Press and hold the or Buttons to adjust volume level as desired.
   • Press and release the or Buttons repeatedly to skip tracks.
5. If the unit is paired to a Cell Phone and a call is incoming during an active music session, press the Button to pause the music playback. Then speak to the built in microphone to answer the call. When your call is complete, press the Button to end the call and resume to music playback.

Notes:

1. When the external BT Device searched the unit, our model number "MMA3626" will appear on the display of external BT Device.
2. If while pairing you are asked for a code please try "0000" or "1234".

Normal operation after pairing:

1. Power on the external BT Device and enter to BT playback mode.
2. Power on the unit and enter to BT mode as previously instructed. The Blue Indicator on the rear of unit will illuminate and blink. The unit also will sound a prompt "Bluetooth ready for connection".
3. Wait a few seconds until the unit is automatically paired to the external BT Device. The unit will sound a prompt "Bluetooth connected" and the BT Indicator will stop blinking.
4. After pairing is complete you may now play music and answer calls with your external BT Device.

TF (Micro SD) Card Playback Mode:

To play the music in Micro SD Card:

1. In power off mode, insert the Micro SD Card (not included) into the TF (Micro SD) Card Slot on the rear of unit with contacts facing up as illustrated below:
2. Power on the unit and enter to TF (Micro SD) Card mode as previously instructed. The unit also will sound a prompt "Memory Card" then automatically play the music in it.
3. During playback:
   • Press the Button to pause, press again to resume normal playback.
   • Press the orButtons repeatedly to skip tracks.

USB Device Playback Mode:
To play the music in USB Device:

1. In power off mode, insert the USB Device (not included) into the USB Port on the rear of unit as illustrated below:
   
2. Power on the unit and enter the USB mode as previously instructed. The unit will sound a prompt "USB". then automatically play the music in the it.
3. During playback:
   • Press the Button to pause, press again to resume normal playback.
   • Press the or Buttons repeatedly to skip tracks.

Notes:

• Up to 8 GB Micro SD Card/USB Device the unit supports to play.
• Before replacing Micro SD Card/USB Device, make sure the unit has been powered off.
• When inserting the Micro SD Card/USB Device, make sure the direction you selected is correct. Never insert violently to avoid damaging the Micro SD Card/USB Device or the unit.
• If it doesn't work, please check if the direction is correct.
• You also need to download the desired music in MP3 format into the Micro SD Card/USB Device before insert into the unit.

TROUBLESHOOTING

Check the following before requesting service:

SYMPTOM	POSSIBLE CAUSE	POSSIBLE SOLUTION
Can't power on	Built in battery drained	Recharge the built-in battery.
No sound or sound weak	Volume of the unit was set to minimum position	Increase the volume level by press and holding theButton
	Volume level of paired device is in low level	Rise the volume level of the paired BT device
Sound distortion	Volume level too high	Reduce the volume level by press and holding theButton
	Volume level of the paired device too high	Reduce the volume level of the paired BT device
BT not functioning	The external BT Device had NOT paired to the unit	Pair the external BT Device to the unit.
	The external BT device too far from the unit	Place the external BT device close to the unit

SPECIFICATIONS

Power Source	Built-in DC3.7V, 400 mAH (1.48WH) rechargeable Li-ion battery; Recharge by DC5V through DC IN Jack (Micro USB Port)
Impedance of Speakers	2 x 4ohm; 3W
Audio Power	1.5W per Channel (Total 3 W RMS)
BT Version	4.1
BT Operation Distance	32 Feet in open area

PACKAGE INCLUDES

1 x Owner's Manual
1 x USB Connection Cable (For charge only)
SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Magnavox MMA3626 - Portable Speaker with Bluetooth Manual