Magnavox MMA3652 - Compact Portable Speaker with Decorative Lights Manual

Table of Contents

LOCATION OF CONTROLS

The unit has a built-in Li-ion rechargeable battery, recharge it before use or when the battery is drained as follows:

Connect the Micro USB Plug from the supplied USB Connection Cable to the Micro USB Port on the unit.
Connect the full sized USB Plug from the supplied USB Connection Cable to the USB Port on Computer or USB Charger (Not included). Charging will automatically start.
- While charging, the Red Indicator on the unit will illuminate. When finished charging, it will turn off.
- While charging, you can also play and listen music at the same time.

Notes:

Your battery will last longer if you're following these simple guidelines for caring and storing.

Before first time use (or recharge it when the battery is drained), charge it approximately 2 hours.
Recharge and store the unit within the temperature range of 5°C~35°(40°F~95°F).
Do not charge longer than 24 hours. Excessive charging or running the unit until battery fully drains will damage battery. Battery life will be extended if you keep the battery fully charged.
Battery life naturally shortens slowly over time.
The rechargeable battery incorporated in this product is not user replaceable.

BT (Bluetooth) pairing:

First time use or re-pairing the unit to a new BT Device, pair as follows:

Power on the unit by sliding the Power ON/OFF Switch to ON position. The Blue Decorative LED Lights on the unit will illuminate and blink.
Power on the external BT Device and enter to BT searching mode. Start pairing following the on screen instructions from the external BT Device. When paired, The Decorative LED Lights on the unit will turn to color blinking mode.
If pairing is complete you may now play music with your external BT Device.
During playback, use the Controls on the paired BT Device to adjust volume level; pause; skip tracks as usual.
When finished listening, slide the POWER ON/OFF Switch to OFF position to shut off the unit.

Notes:

When the external BT Device searched the unit, our model number "MMA3652" will appear on the display of external BT Device.
If while pairing you are asked for a code please try "0000" or "1234".

Normal operation after pairing:

Power on the external BT Device and enter to BT playback mode.
Power on the unit by slide the PowerON/OFF Switch to ON position. The Blue Decorative LED Lights on the unit will illuminate and blink.
Wait a few seconds until the unit is automatically paired to the external BT Device. The Decorative LED Lights on the unit will turn to color blinking mode.
After pairing is complete you may now play music with your external BT Device.

Check the following before requesting service:

SYMPTOM	POSSIBLE CAUSE	POSSIBLE SOLUTION
Can't power on	Built-in battery drained	Recharge the built-in battery.
No sound or sound weak	Volume level of paired BT device is in low level	Rise the volume level of the paired BT device
Sound distortion	Volume level of the BT paired device too high	Reduce the volume level of the paired BT device
BT not functioning	The external BT device had NOT paired to the unit	Pair the external BT device to the unit.
BT not functioning	The external BT device too far from the unit	Place the external BT device close to the unit

Power Source	Built-in DC3.7V, 400 mAH (1.48WH) rechargeable Li-ion battery; Recharge by DC5V through DC IN Jack (Micro USB Port)
Impedance of Speakers	3 ohm; 3W
Audio Power	1.5W (RMS)
BT Version	4.1
BT Operation Distance	32 Feet in open area