Sony RSE-500 Operating Instructions Manual page 38

FAVA
IM
€ seldey)
Starting Communication
If the connection failed
If the system cannot make a connection with the
remote site, the following message and the ISDN cause
code appear for five seconds and the DIAL LIST menu
appears again.
CONNECTION FAILED !
CAUSE CODE = 017
For details on the ISDN cause code, see "ISDN cause
codes" on page A-7 (EN).
To return to the main menu
Move the cursor to <EXIT> and press ENTER. The
main menu appears.
To connect to an unregistered remote site
1 If the DIAL LIST menu is displayed. select
<EXIT> to display the main menu.
If you have disabled the main menu, the following
screen is displayed when you select <EXIT>.
Proceed with the process from this screen.
—
DIAL LIST
DIAL KEY
BUSY
SETTING
When using the Remote Commander. skip the
operation above.
2 Select DIAL KEY. When using the Remoter
Commander, press DIAL.
The following screen appears.
OK EY —- -—
SELECT:1Bj 2B SINGLE DUAL
1ST DIAL:
[KKK KKK KKK AKA K AK AK KKK KE ]
SUB ADDRESS: [XXKKKKKKKK]
2ND DIAL:
LX KKKKKK KEKE KKK KK EKKKKK)
SUB ADDRESS: [x*xxxxxxxx1
0123456789 8
«EXIT» <DIAL>D
3 Select the transmission rate (via an ISDN line from
1 B or 2B, via the V.35 interface from SINGLE or
DUAL) using € or ®, then press y.
4 Enter the telephone number for B1-channel of the
remote site using € or **, then press ENTER one
by one.
When using the Remote Commander, you can
enter the number using the number keys.
The telephone number is entered in the telephone
number box.
* An asterisk is displayed where nothing is entered.
5 Press Y and enter the subaddress for B1-channel of
the remote site using € or ®, then press ENTER
one by one.
When using the Remote Commander, you can
enter the number using the number Keys.
The subaddress is entered in the subaddress box.
* An asterisk is displayed where nothing is entered.
6 Press * and repeat steps 4 and 5 to enter the
second telephone number and subaddress.
7 After entering the subaddress for the second
telephone number, move the cursor to <DIAL>
using ¥, then press ENTER.
When the remote site is connected, the picture
from the remote site is displayed.
The subaddress function may not be worked properly
depending on types of switchboards.