Installation Of The Bi2115; Installation Troubleshooting; Initial Start-Up - U-Line Echelon BI-2115 Installation Manual

9 Install the Unit

Installation of the BI2115

1. Open the water supply valve in the main water source.
2. Make sure the ON/OFF switch is in the OFF position (see
Figure 37).
3. Plug in the power cord.
4. Gently push the unit into position. Be careful not to
kink the water supply line or entangle the electrical
cord.
5. Re-check the leveling, from front to back and side to
side. Make any necessary adjustments. The unit's top
surface should be approximately 1/8" below the
countertop.

Installation Troubleshooting

Q:
Problem
Water is leaking under the unit.
A:
Solution
A water leak under the unit is most likely caused by a bad
connection in the water supply line. Make sure the water
line's brass fitting is screwed tight to its valve and
threaded correctly.
Q:
Problem
The door remains open unless it is pushed closed.
A:
Solution
The hinges should be self-closing when the door is open
approximately 8". If this is not the case, make sure the
closers (at the bottom of the hinge pin) are clean, greased
and installed correctly. Also, re-check leveling from front
to back of the unit and readjust if necessary. Make sure
that pivot plate is installed correctly.
Q:
Problem
The custom overlay door was designed to align with the
rest of the cabinet doors, but the unit has crept forward.
A:
Solution
Make sure that the electrical cord and water supply line
are not obstructing the installation.
08/2006
BI-2115 — Ice Maker
10 Start-Up for the First Time

Initial Start-Up

All Units are shipped with controls that are preset. No
initial adjustments are required.
Once installation and leveling is complete, the unit is
ready for initial start-up and operation. The ON/OFF
switch is located on the lower front panel (see Figure 37).
Figure 37
1. Put the ON/OFF switch in
the ON position.
2. As soon as the ice maker
mold reaches the proper
temperature, the ice
maker mechanism will fill
the mold with water.
Note: The first cubes may be
small because of air in the
water line. Subsequent cubes
will be standard size.
3. The ice maker will
continue to produce until the bin is full. You may
interrupt production by raising the bin arm into an
upright and locked position (see Figure 38). While the
bin arm is locked, the unit will maintain temperature
for ice storage.
It is possible that dirt or scale will dislodge in the water
line. Always throw away all ice cubes made during the
first twenty-four (24) hours of operation.
About Settings
No adjustments should be necessary at this time. For
information about Adjusting the Temperature Control
and Adjusting Ice Cube Size, see the Use and Care Guide.
15
2
1
ULIN_0132_A
Figure 38
IMPORTANT
www.U-LineService.com