Starting A Warm Engine; Break-In Procedures - Yamaha YZ 2016 Series Owner's Service Manual

STARTING A WARM ENGINE

EASB296046
Follow the same procedure as for starting a
cold engine with the exception that the starter is
not required when the engine is warm.
TIP
If it fails to start, fully open the throttle grip and
give 10 to 20 slow kicks to clear the engine of
the rich air-fuel mixture retained in it.

BREAK-IN PROCEDURES

EASB296047
A break-in is important so that rotating portion,
sliding surfaces, and mounted areas may fit
one another, and that the rider may become ac-
customed to the machine.
ECA
NOTICE
Before running, do maintenance on the air
filter element.
Refer to "CLEANING THE AIR FILTER ELE-
MENT" on page 3-12.
1. After warming up the engine, drive it for
about 20 minutes at a throttle opening of 1/2
or less.
2. Make a pit stop, and check mounted areas
for looseness, oil leaks, or other problems.
3. Then, drive it for about 40 minutes at a throt-
tle opening of 3/4 or less.
4. Make a pit stop again, and thoroughly check
mounted areas for looseness, oil leaks, or
other problems. Thorough checks and ad-
justments are required in particular for
stretch of cables, free play of the brake,
stretch of the drive chain, looseness of the
spoke, and so on.
ECA
NOTICE
After a break-in or after each race, always
check the points shown in "TORQUE-
CHECK POINTS" for tightening torques and
retighten them. (Refer to "TORQUE-CHECK
POINTS" on page 1-24.)
Also when the following parts are replaced,
a break-in is required.
• Cylinder and Crankshaft: A break-in is re-
quired for about an hour.
• Piston, Piston ring, Valve, Camshaft, and
Gear: A break-in is required for about 30
minutes at a throttle opening of 1/2 or less.
STARTING AND BREAK-IN
Observe the condition of the engine careful-
ly during a break-in.
For checkpoints for a break-in, see "MAIN-
TENANCE AFTER BREAK-IN". If any prob-
lem is found, immediately stop the engine
and make a checkup.
1-22