Table of Contents
Advertisement
SETTING THE UNIT PRIOR TO OPERATION
+ Before operating the unit, be sure to set it as shown below.
Set the TAPE 2 MONITOR button to
OFF {TAPE 2 indicator goes off).
Press the POWER
switch to
lz
=
Set the VOLUME
control to
the "MIN" position.
the ON position.
Set the BALANCE contro! to
the center position.
Press the SPEAKERS switch corresponding
to the speaker system to be used.
LISTENING TO THE BROADCAST
« Check that all terminals are properly connected before switch-
ing on the unit.
MANUAL/AUTO
TUNING
(FM/AM
re-
ception)
1, Press the TUNER button of the function buttons.
2. Press the FM/AM selector button to select your
desired broadcasting band.
3. Use the TUNING buttons to locate the frequency
of the desired station.
{Manual tuning] (FM/AM reception)
Press either TUNING button and release it quickly. The frequency
will change by one step each time the button is pressed. Press
as many times as necessary to tune in the desired station.
Steps change in the following way.
FM 100 kHz, AM 10 kHz.
[Auto tuning] (FM reception)
Press the button until the frequency starts to change, then re-
lease it. The tuner will automatically search for a broadcasting
station and stop when one is found.
To search for another station, press again.
[High speed manual tuning] (FM/AM reception)
Keep either TUNING
buttons pressed. The frequency changes
continuously, and stops when the button is released.
NOTE:
The TUNED indicator will not function for broadcasts received
over long distances or when signals are weak.
8
<ARB7067>
When Receiving FM Broadcasts:
Note on Auto Tuning
+ Preset extremely weak stations with manual tuning.
The TUNED Indicator
When the TUNED indicator is not lit, reception is not possible
even if the tuning frequency is correct. This is because the an-
tenna terminal input is too weak. Check whether the antenna
cable is firmly connected. If it is, consult your nearest dealer and
install an outdoor antenna.
Advertisement
Table of Contents
