Setting The Unit Prior To Operation; Graphic Equalizer Controls; Cece Eceee Cece Eee Eees - Pioneer SX-2900 Operating Instructions Manual

SETTING THE UNIT PRIOR TO OPERATION
e Before operating the unit, be sure to set it as shown below.
Set the VOLUME control
to the ''O"' position.
Press the SPEAKERS switch
corresponding to the speaker
system to be used.
Set the BALANCE control
to the center position.
Set the TAPE 2 MONITOR button to OFF
(TAPE 2 indicator goes off).
GRAPHIC EQUALIZER CONTROLS
The advantage of the GRAPHIC EQUALIZER over conventional tone 3.3 kHz: The 3.3 kHz control will add brilliance and clarity to brass
controls is that with the five controls of the GRAPHIC EQUALIZER it instruments and violins.
is possible to control five different narrow, distinct sections of the audio 10 kHz: The 10 kHz control can be used to make up for missing high
band. With conventional tone controls a setting for a bass or treble boost frequencies absorbed by the environment and to add a natural
or cut will also affect the lower or upper mid frequencies. The frequency crispness to music.
bands controlled by the five slide controls have been chosen to yield
the maximum possible control action within the audio spectrum. se eco ten Emphasize
a en. en | rn. ae frequency range.
100 Hz: The 100 Hz control is very useful in enhancing low bass notes SJ] S/ (= SE SE SIE
as in organ music. =h=-=8=-=8==8#="=H=
330 Hz: The 330 Hz control will allow you to vary the upper bass |S SE 1 IE De-emphasize
frequencies. as sae om 7 frequency range.
1 kHz: The 1 kHz control is the presence control and can be used
very effectively to emphasize, or de-emphasize vocalists. oT ee
@g
<ARB1286>