TurboChef HHC-3240 Installation Manual page 10

6 INSTALLATION
NOTE: When installing any gas pipes and/or making connections, observe all local
gas and building codes (refer to the regulations in force in the country in which the
appliance is being installed). Use the proper thread-sealing compound when installing
gas pipes. DO NOT
Remove the oven's back panel and install the 8" (203.2 mm) gas pipe (refer to
4.9
page 2) between the two ovens.
NOTE: Unless you are installing a triple-stacked oven, proceed to STEP 5, page 7.
If installing a triple-stacked oven, remove the gas pipe plug in the top of the
4.10
middle oven and repeat STEPS 1.1-2.6 (skip step 2.2), pages 3 and 4 for the top
oven.
Position the base ovens beneath the raised oven.
4.11
Lock the casters of the base oven.
4.12
Lower the raised oven onto the base ovens.
4.13
Remove the maneuvering casters from the back of the oven.
4.14
Immediately discard the maneuvering casters. These casters
4.15
are not designed to be used again.
Ensure that all the holes in the rear of the oven are plugged
4.16
with the provided bolts.
Install the stacking brackets to the middle and top ovens. Both stacking brackets
4.17
MUST be attached to the ovens.
WARNING: When installing any gas pipes and/or making connections, observe
all local gas and building codes (refer to the regulations in force in the country in
which the appliance is being installed). Use the proper thread-sealing compound when
installing gas pipes. DO NOT use Tefl on
Remove the burner compartment cover(s) and install the 8" (203.2 mm) gas pipe
4.18
(refer to page 2) between the middle and top ovens.
use Tefl on tape as thread sealant.
®
tape as thread sealant.
®
Step 4.9
Step 4.10
Step 4.14
Step 4.17
Step 4.18
Stacking Brackets