Using Your Appliance - universalblue BORA 4052BDC User Manual

(fig. 9).
You can also mount the blades in
the fan body before making the
electrical connections.
The fan has reversible blades
BLADE BALANCE KIT
Included in the purchased product you will
find a kit supplied to prevent the blades
from moving unbalanced.
The fan may wobble during functioning
due to an irregularity in th eblades or
blade support. Also, improper installation
or an inlcined angle can cause additional
problems.
It is recommended to follow the next
procedure to solve any of these problems :
• Make sure that all blades are screwed
firmly into their mounts and are tight to
the fan body.
• Looking at the fan from below, check
and make sure that no blade holder is
bent so all the blades are in the correct
position.
• Using a ruler you can check the blade
route. Simply place the ruler against the
roof vertically, and note the distance
from the edge of the blade to the roof.
Carefully spin the blades with your
hand to check all the blades. If the
blades are not aligned, the holder can
be slightly bent up or down to align it
with the rest of the blades.
If after following all these steps the problem
is not solved, a small adjustment must be
made using the balance kid provided.
• Turn the fan on and change the speed
until the most noticeable swing occurs
(usually the highest speed).
• Turn off the fan. Select a blade and
place the balancing clip on the edge of
it, between the holder and the tip.
• Turn the fan back on and see if the tilt
has improved or worsened. Turn the fan
off and change the clip to another blade
to check again. Repeat this process for
all blades and note which blade has the
most noticeable improvement.
• Put the clip back on the blade where
you noticed the greatest improvement.
Move the clip along the blade and turn
on the fan to find the position where the
clip offers the better improvement.
• Next, remove the clip and place one of
the balance weights on the point where
the clip was placed. To do so separate
the white sticker with your fingernails
or, if necessary, carefully use a knife or
scissors.

USING YOUR APPLIANCE

REMOTE CONTROL
The device incorporates a remote control,
for a more comfortable and efficient use.
In order for the remote control to work, it
must always be aimed at the fan.
Before you start using it, please take a few
minutes to familiarize yourself with the
functions:
19. ALL OFF button: Press this button to
turn off the fan and light.
20. Press this button to turn on and
off the light. If you want to change the
light colour, press it until the wanted
colour is set.
21. Press this button to set SUMMER
mode function.
22. Press this button to set NATURAL
mode function.
23. button: Press this button to set the
WINTER mode function.
24. Press this button to turn the fan on
and off.
25. 1 to 6 buttons: Press any of these
buttons to set the fan speed, being 1
the lowest speed and 6 the highest.
26. 2H: Setting for the fan to turn
off automatically after two hours of
operation.
27. 4H: Setting for the fan to turn off
automatically after four hours of
PT
21