Advertisement
Available languages
Available languages
ENGLISH
(these screws are not supplied with this
equipment).
REMOTE CONTROL CONNECTION
L : AC IN 220-240V
N : AC IN 220-240V
14.
Bracket
15. Yellow/green
16. Remote control
17. Yellow/green
18. Receiver place
See picture 06 on page 8.
STEP BY STEP
Here at UniversalBlue we have
created videos to explain the
assembling process. You can
find them in our YouTube
channel, by clicking on the
following link, or scanning this QR code.
Select the model you have purchased from
the list..
Youtube link:
https://www.youtube.com/
playlist?list=PLWr7XjixBD4z5wryoYFEMFvDYKfkgIKlc
Or scan the QR code:
You can see the whole assembling
sequence in picture 05 on page 7.
The images are for guidance only and
should be used to support the installation.
• Step 01: Open the box and remove the
fan (fig. 1).
• Step 02: Mount the support plate on the
ceiling with the appropriate screws.
20
Make sure it is securely fastened.
Caution: The screws supplied are for
wooden beams and concrete ceilings.
(fig. 2).
• Step 03: Remove the unthreaded screw
from the extension rod and save it.
Also remove the upper screws in the
hemisphere of the extension rod and
reserve them.
• Step 04: Pass through the support rod,
the canopy and the lower cover. Then
run the cables through the inside of
the rod. Fit the rod into the motor body
and replace the previously removed
threadless screw and tighten the motor
body screws (fig. 3).
• Step 05: Slide the lower cover to the
engine body.
• Step 06: Secure the support rod to the
engine using the engine pin and nut.
• Step 07: Place the hemisphere of the
support rod, tighten it with the screw
and connect the electric cable coming
from the roof to the screw terminal
located at the top of the support rod,
tighten the screws.
• Step 08: Then hang the fan to the
ceiling and make the appropriate
cable connections. Make sure that
the receiver is inserted into the top of
the support plate (see Connecting the
remote control).
• Step 09: Slide the top cover up and align
the holes to the screws, turning the top
panel until it locks into place. Then
tighten the screws. (fig. 4)
• Step 10: To mount the blades, center the
blade slots with the motor attachment
heads and tighten the screws. (fig. 6)
• Step 11: To mount the light, assemble
and align the holes in the back of the
LED light with the three screws on the
motor connection plate. (fig. 7)
• Step 12: Then tighten the three screws
on the LED board and connect the cable
along with the motor cable. Please
make sure that the lighting kit is
securely fastened after tightening the
screws. (fig. 8)
• Step 13: Place the lampshade on the fan
and turn it clockwise until it is fixed
Advertisement
