Assembly And Installation; Using The Appliance - universalblue UVP1102-24 User Manual

ENGLISH
PRODUCT FEATURES
The package contains the following items,
besides this manual and the product
warranty. See pictures 01 on page 4.
Note: The picture is for reference only. The
content may vary depending on the model.
1. Front grille.
2. Front mounting nut.
3. Blades.
4. Back mounting nut.
5. Rear grille.
6. Motor shaft.
7. Fan head (motor).
8. Control panel.
9. Input for power cable.
10. Adjustable head angle Shaft.
11. Upper tube (fan foot).
12. Lower tube (fan foot.).
13. Base.
14. Washer and fixing screw.
15. Remote control.
You can check the product features in table
01 on page 8.

ASSEMBLY AND INSTALLATION

Before unpacking the product, memorize
the position of each accessory in case you
need to repack it in the future.
The fan is packed with the grilles removed.
You must place the grilles before operating
the fan.
Warning: Never operate the fan without its
base or other parts.
Operate the fan only in an upright position;
any other position could create a dangerous
situation.
Assemble the base and other parts of the
appliance considering the following notes.
Note: the images are for guidance only and
should be used to support the installation.
24
See image sequence 04 (Fig. 01 - 08) on
pages 6-7:
• Unpack and take out every part of the
fan.
• Insert the lower tube (12) into the hole
in the base (13), place the washer (14)
under the base and tighten the base
with the L-shaped screw (14) clockwise
(Fig. 01).
• Insert the upper tube (11) into the centre
of the lower tube (12), align the hole with
the small protrusion on the opposite
side. Make sure that they are correctly
fixed with the fixing screw (Fig. 01).
• Insert the fan head (7) with the upper
tube (11) and tighten with the screw
provided. (Fig. 01)
• Use the grille fixing nut (4) to fix the rear
grille (5) to the fan head (7). (Fig. 02-03)
• Then use the blade retaining nut (2) to
fix the fan blade (3) (Fig. 04-05).
• Centre the front grille (1) with the rear
grille (Fig. 06), turn it clockwise to close
it (Fig. 07).
• Once closed, securely fasten it using
screws (Fig. 08).
• If you want to change the height of the
fan to a lower height, you must remove
part 12 from the mounting.
• If the fan is to be used as a desktop
fan, remove parts 11 and 12 from the
assembly.

USING THE APPLIANCE

This device is easy to use and does not
require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
(
Control panel see picture 02 on page 5)
16. Light indicator. This section shows
which options are active.
17. Timer. Activation of the timer,
possible use of 1 hour, 2 hours, 3
hours and 4 hours. The desired
time is displayed on the fan. To
deactivate the timer, press the
button again after the maximum