Advertisement
Available languages
Available languages
ENGLISH
• You must loosen the two screws on the
side part so that the top cover can be
assembled.
Fan body:
• First loosen the two screws located on
the top part of the fan body, where the
downrod is going to be inserted.
• Remove the safety pin from the
downrod and save it. (Pic. 2)
• Then follow this sequence: Insert the
down rod through: the top cover and the
bottom cover (pic. 3)
• Introduce the cables through the down
rod too (Pic. 4)
• Once you have inserted the cables,
Fit the rod in the motor housing and
insert again the safety pin previously
removed. Then, tighten the screws of
the motor housing which have been
loosened before (pic. 5)
• Once you have finished, adjust the
bottom cover and hide the connection
between the down rod and the motor
housing. (Pic. 6)
How to assemble the blades:
• First you need to fix the blades to the
support. Place the blades so that the
three holes are aligned with the three
holes on the support. Fix with the
supplied screws. The blades have been
designed to fit perfectly. The screws
must be in vertical position with
respect to the blade. Tighten evenly all
the screws to the blades to prevent the
fan from swinging.
• Then you must screw the blades
support to the motor housing. To do
this, align the two holes on the blades
support with the two holes from the
bottom part of the motor housing. Fix
with the screws supplied. Keep in mind
you need to turn the light support to
gain visual access to the holes on the
motor housing (Pic. 7)
Electrical connections:
See picture 05 on page 8.
See table 02 on page 10.
28
We will now proceed to connect the cables
coming out from the ceiling to the motor
leads coming from the fan body. To make
the process easier you may want to get
somebody´s help to hold the fan lifted while
you do the pertinent electrical connections,
• There are four coloured wires coming
from the top of the motor
• Connect fan wires to ceiling wires
following the instructions on table 02
and 03.
• Cap with three wire connector if this is
necessary. (Pic. 9)
• After this fix the whole fan to the
ceiling bracket. Slide the top cover up
and align the holes to the screws you
have previously loosened on the ceiling
bracket, turning it until it is fixed. Then,
fix the screws (Pic. 10)
Note: When making connections, twist the
stripped copper threads of wires tightly
together and cap off with the connectors
provided if is necessary, again by twisting
the connector firmly into the copper. Be
certain that the bare copper of the wires
are fully encased by the wire connectors,
to prevent electrical shock from occurring.
Spread the wires apart with the ground
cord and neutral wires on one side and
fan and light wires on the other side of
the outlet box. Turn upward and push
carefully into the outlet box. All splices and
connections are to be capped with listed
wire connectors suitable for the number
and gauges of wire used. See table 03 on
page 11
Glass assembly
• Place the bulb (not included) The fan
use 1 60W E27 bulb. When placing the
bulb, make sure they do not touch the
lamp cover or lamp holder.
• Lastly, put the glass cover very carefully,
as it is a very fragile part. The glass
cover is held in place by metal straps
that are attached to the bracket. Fit the
ceiling panel between the metal straps
and the bracket. Make sure it is well
fixed, otherwise it could fall and break
Advertisement
