Advertisement
Available languages
Available languages
ENGLISH
A hose that attaches to a tap
can burst if it is installed on the
same
dishwasher. If your sink has
one, it is recommended that the
hose be disconnected and the hole plugged.
Connection of drain hoses
Insert the drain hose into a drain pipe with
a minimum diameter of 4 cm, or let it run
into the sink, making sure to avoid bending
or rimping it. The height of drain pipe
must be less than 1000 mm. The free end of
the hose must not be immersed in wáter to
avoid the back flow of it.
How to connect the safety supply hose
(see image 03 on page 5).
11. Main power cable: pull the safety
supply
hoses
compartment located at rear of
dishwasher.
12. Water Inlet: tighten the screws of the
safety supply hose to the faucet with
thread 3/4inch.
13. Drain pipe: turn the water fully on
before starting the dishwasher.
How to disconnect the safety supply hose
(see image 03 on page 5).
14.
Drain hose : Turn off the water.
15. Drain pipe: unscrew the safety supply
hose from the faucet.
16. Sink
Please securely fix the drain
hose in either position A or
position B. See image 03 on
page 5.
How to drain excess water from hoses
If the connection to the drain pipe is
positioned higher than 1000 mm, excess
wáter may remain in the drain hose. It will
be necessary to drain excess water from
the hose into a bowl or suitable container
that is held outside and lower than the
sink.
Water outlet
Connect the water drain hose. The drain
46
wáter
line
as
out
from
storage
hose must be correctly fitted to avoid wáter
leaks. Ensure that the water drain hose is
the
not kinked or squashed.
Extension hose
If you need a drain hose extension, make
sure to use a similar drain hose.
It must not be longer than 4 meters,
otherwise the cleaning effect of the
dishwasher could be reduced.
Syphon connection
The waste connection must be at a height
less than 1000 mm (maximum) from the
bottom of the dishwasher.
POSITIONING AND LEVELLING
• Position the appliance in the desired
location. The back should rest against
the wall behind it, and the sides, along
the adjacent cabinets or walls. The
dishwasher is equipped with water
supply and drain hoses that can be
positioned either to the right or the left
sides to facilitate proper installation.
• Levelling the appliance: Once the
appliance is positioned for levelling,
the dishwasher may be altered via
adjustment of the screwing level of the
feet. In any case, the appliance should
not be inclined more than 2°. (See image
04 on page 5)
Free standing installation (See image 05
on page 5)
The height of the dishwasher, 845 mm,
has been designed in order to allow the
machine to be fitted between existing
cabinets of the same height in modern
fitted kitchens. The feet can be adjusted so
that correct height is reached.
The laminated top of the machine does
not require any particular care since it is
heatproof, scratchproof and stainproof.
Underneath existing work top (See image
06 on page 5)
(When fitting beneath a work top) In most
modern fitted kitchens there is only one
single work top under which cabinets and
electrical appliances are fitted. In this case
remove the work top of the dishwasher by
Advertisement
