Advertisement
Available languages
Available languages
10
PROBLEM
Device does not turn on
Non fucnion drainage pump
Foam in the tub
Stained tub interior
White film on inside surface
There are rust stains on cutlery
POSSIBLE CAUSES
Blown fuse
The electrical current is
not on
Low water pressure
Door of dishwasher not
properly closed
Twisted or trapped drain
hose
Filter clogged
Kitchen sink clogged
Wrong detergent
Spilled rinse aid
Detergent with colourant
may have been used
Hard water minerals
The affected items are not
corrosion resistant
A program
was not run after
TABLAS · TABLES · TABELAS ·
HOW TO PROCEED
Replace the fuse. Disconnect any other
electrical appliances connected to the fuse.
Make sure the dishwasher is on and the
door is closed. Make sure that the plug is
connected to the mains.
Make sure that the water inlet hose is
correctly positioned and the water faucet
is open.
Make sure to close the door properly and
latch it
Check the drain hose.
Check the filter system.
Check the kitchen sink to make sure it is
draining well. If the problem is the kitchen
sink that is not draining , you may need
a plumber rather tan a serviceman for
dishwashers
Use only the special dishwasher detergent
to avoid suds. If this occurs, open the
dishwasher and let suds evaporate. Add
1 liter of cold water to the bottom of the
dishwasher. Close the dishwasher door, then
select any cycle. Initially, the dishwasher
Will drain out the water. Open the door after
draining stage is complete and check if the
suds have disappeared. Repeat if necessary
Always wipe up rinse aid spills immediately
Make sure that the detergent has no
colourant
To clean the interior, use the damp soft
cloth with dishwasher detergent and wear
rubber gloves. Never use any other cleaner
than dishwasher detergent otherwise, it
may cause foaming or suds
Avoid washing items that are not corrosion
resistant in the dishwasher
Always run a wash program without any
crockery after adding salt. Do not select
the Turbo function (if present), after adding
dishwasher salt.
Check the softener lid is secure
19
Advertisement
