Advertisement
Available languages
Available languages
ENGLISH
bottom part so that the top cover can be
assembled.
Fan body:
• First loosen the two screws located on
the top part of the fan body, where the
downrod is going to be inserted.
• Remove the safety pin from the
downrod and save it. (Pic. 2)
• Then follow this sequence: Insert the
down rod through: the top cover and the
bottom cover (pic. 3)
• Introduce the cables through the down
rod too (Pic. 4)
• If you were unable to thread the cables
through the downrod we suggest that
you remove the hemisphere located on
top of the downrod (pic. 5), proceed as
follows:
• Remove the upper screws located
on the rubber hemisphere and save
them. Keep in mind that one of them
will hold the earth wire extension
cable (pic. 5.3) Remove the safety pin
and save it together with the screws
(pic. 5.2 and 5.1) Then thread the
cables and fix it again.
• To fix the hemisphere again: Insert
the safety pin in the holes on the top
part of the down rod (pic. 5.1) Then
bring up the rubber hemisphere until
all the holes are aligned (pic. 5.2)
Last, fix it with the screws you have
removed earlier and fix the earth
wire with one of them (pic 5.3)
• Once you have inserted the cables,
Fit the rod in the motor housing and
insert again the safety pin previously
removed. Then, tighten the screws of
the motor housing which have been
loosened before (pic. 6)
• Once you have finished, adjust the
bottom cover and hide the connection
between the down rod and the motor
housing. (Pic. 7)
How to assemble the blades:
• First you must screw the blades support
to the motor housing. To do this, align
the two holes on the blades support
34
with the two holes from the upper
part of the motor housing. Fix with the
screws supplied. (Pic. 8)
• Then you need to fix the blades to the
support. Place the blades so that the
three holes are aligned with the three
holes on the support. Fix with the
supplied screws. The blades have been
designed to fit perfectly. The screws
must be in vertical position with
respect to the blade. Tighten evenly all
the screws to the blades to prevent the
fan from swinging. (Pic. 9)
• Now fix LED light kit. This is supplied
with a magnetic bracket or with screws.
To proceed, first connect wires from
the motor to wires from LED light kit.
Once connected, match light kit to light
bracket. If your model has magnets,
bring it closer to it so it is magnetised
and fixed to support plate, but if your
model has screws use them to fix it to
support plate. (Pic. 10).
Electrical connections:
• Put the fan on the ceiling bracket
by introducing the down rod in the
receiver bracket and turn it until you
hear a "click" sound, insert the slot
located on the hemisphere of the down
rod, in the tab of the receiver bracket.
(pic. 11).
• Then we can proceed to do the pertinent
electrical connections. See image 05 on
page 9:
• First place the receiver between the
bracket and the fan, with the smooth
part facing upwards (pic. 12).
• Once placed, connect the cables
coming out of the ceiling using the
circuit board located on the receiver
support. Connect the phase wire to L
and the neutral wire to N.
• Then connect the cables coming
out of the ceiling bracket and the
fan body to the receiver wire inputs.
Connect the earth wires too (pic. 13).
• Once the electrical connections are
completed, slide the top cover up
and align the holes with the screws
Advertisement
