Switching The Device On And Off - universalblue BALTICO 4060 User Manual

IMPORTANT:
recommends the use of the eco program as it is the most efficient program in
terms of combined energy and water consumption. This program has been specially
designed to comply with EU eco-design regulations.
NOTE: Data provided for all programs except the ECO program are for
reference only.

10. SWITCHING THE DEVICE ON AND OFF

TURN ON THE DISHWASHER
• Open the dishwasher baskets and insert the dishwasher. It is recommended to
load the lower basket first.
• Add detergent.
• Connect the device to the light, observing the voltage instructions of the device.
• Make sure the water supply is connected to maximum pressure. Close the
dishwasher door and press the "Power" button.
• Press the " Program " button to select the desired wash cycle.
NOTE: A "click" is heard when the door is perfectly closed.
When you have finished washing, you can turn off the switch by pressing the
"Power" button.
CHANGE THE SELECTED PROGRAM
A cycle that is running can only be changed if it has been running for short time.
Otherwise, the detergent may have already been released and the appliance may
contain water.
Press the "Power" key to cancel the program and turn it on again. Select the desired
wash program.
NOTE: If you open the door during washing, the machine stops and a warning
alarm sounds. The display shows code E1. When the door is closed, the
machine will continue to run after 10 seconds.
The program lights show the state of the dishwasher:
a) One of the lights in the program lights up: it means that the cycle is running.
b) One of the program lights flashing: it means that the cycle is paused.
If all the lights start flashing, please turn off the appliance, turn off the water supply to
the appliance and contact the service technician.
IF YOU FORGOT TO INCLUDE ANY UTENSILS IN THE DISHWASHER
For dishes with standard soiling, the manufacturer