Related Manuals for Wickes 161414
Summary of Contents for Wickes 161414
- Page 1 Manual Mixer Shower Fitting instructions Please note: Tap head shown is for illustration purposes only. Please keep these instructions for future reference and request of replacement parts.
-
Page 2: Table Of Contents
We have taken great care to ensure that this product reaches you in perfect condition. However should any parts be damaged or missing please contact your point of purchase. This does not affect your statutory rights. In addition if you require replacement parts your point of purchase will be happy to assist. -
Page 3: Tools Required
Tools Required (Tools not supplied) Parts Supplied Descriptions Lever Grub screw Handle seat Mixer body Sealing washer Elbows Copper olive Fixing nuts Flange Wall screws Mounting bracket Wall plugs Long wall screw Lower riser rail bracket Wall plugs Hose retainer Riser rail Shower hose Handset... -
Page 4: Before You Start
Before You Start Hot water should be stored and distributed at a temperature of not less than 60°C which will help minimise the build-up of limescale. For further details contact your Local Water Authority. This shower should be installed in compliance with the Water Regulations. (a) Identify all components and check pack contents. -
Page 5: Installation
Installation -Fitting the mixer shower 1. Flush pipe work prior to installation to remove debris from the system. 2. Turn off water supply following system flushing. 3. Prepare hot and cold inlet pipes (15mm) with centres 150mm apart, cold supply to the right. For water inlet pipes, leave a minimum of 10mm exposed. - Page 6 10. Push mixer body(4) onto the mounting bracket(11) and twist to engage lugs. It may require some manoeuvring to ensure vertical alignment of the mixer body(4). Note: if you need to readjust the position of the mounting bracket, follow these steps: Remove mixer body(4) from mounting bracket(11) and realign as marked.
- Page 7 -Fitting the Shower Kit 1. Mark and drill 2 holes (the centre of two holes 532±3mm) on the wall, ensure that the shower hose(19) will not be over extended when the slider(21) is in its highest position. 2. Once holes are drilled , insert wall plugs(16) to wall. 3.
-
Page 8: Aftercare
7. Fit cap(13) to the riser rail brackets. 8. Insert hose seal to cone end provided in pack and connect to handset(20) and tighten. DO NOT OVER TIGHTEN. Insert second seal into opposite end of shower hose(20) and connect to outlet of the mixer valve(4) through the hose retainer(17).