Advertisement
Installation
-Fitting the mixer shower
1. Flush pipe work prior to installation to remove debris
from the system.
2. Turn off water supply following system flushing.
3. Prepare hot and cold inlet pipes (15mm) with centres
150mm apart, cold supply to the right. For water inlet
pipes, leave a minimum of 10mm exposed.
4. The valve will normally ship with the water outlet to
the bottom and the cold inlet to the right (indicated
by a blue dot).
5. Fit elbows(6) with sealing washer loosely to the
mixer body(4). Fit mounting bracket(11) to mixer
body.
6. Place mixer body against the wall with elbows over
the pipe tails and mark around the mounting bracket
where it sits on the wall. Remove mixer body, place
mounting bracket in centre of the outlined bracket
position and mark points for fixing holes.
7. Remove the elbows from the mixer body.
8. Important - Use appropriate fixings suitable for wall
type/construction. Drill holes to suit required fixings
(Use wall plugs[12] supplied if suitable).
9. Secure mounting bracket to the wall using the wall
screws[10] supplied (if suitable), but not fully tighten.
5
11
6
4
11
4
12
11
10
Advertisement
