Advertisement
10. Push mixer body(4) onto the mounting bracket(11)
and twist to engage lugs. It may require some
manoeuvring to ensure vertical alignment of the
mixer body(4).
Note: if you need to readjust the position of the
mounting bracket, follow these steps:
Remove mixer body(4) from mounting bracket(11)
and realign as marked. Then tighten screws holding
mounting bracket(11) and refit mixer body.
11. Fit flange(9) to inlet pipe ends, secure elbows(6) to
inlet pipe ends using fixing nuts(8) and copper
olive(7), but do not tighten for this step.
12. Connect elbows(6) to mixer body, ensure that the
sealing washer is fitted in the nuts.
13. Tighten all the nuts.
14. Turn on the water supplies and check for leaks.
15. Unscrew the grub screw(2) from the handle seat(3).
Place the handle seat(3) onto the cartridge, to
check that it moves freely left and right. When
satisfied, tighten the grub screw(2) using an allen
key(24).
16. Refit lever(1) to handle seat(3).
6
11
4
6
4
24
9
8
7
6
3
2
1
Advertisement
