Download Print this page

Wickes W INST 300 Instruction Manual

Exposed bath shower mixer

Advertisement

Quick Links

EXPOSED BATH SHOWER MIXER
INSTRUCTION MANUAL
W INST 300
Please note:
Tap heads shown is for illustration
purposes only.

Advertisement

loading

Summary of Contents for Wickes W INST 300

  • Page 1 EXPOSED BATH SHOWER MIXER INSTRUCTION MANUAL W INST 300 Please note: Tap heads shown is for illustration purposes only.
  • Page 2 CONTENTS GUARANTEE GENERAL SAFETY INSTRUCTIONS PARTS SUPPLIED HOW TO INSTALL AFTER CARE GUARANTEE All products parts are manufactured to the highest standard and are covered by a 2 year manufacturing guarantee. GENERAL SAFETY INSTRUCTIONS Prior to drilling into walls, check there are no hidden electrical wires, cables or water supply pipes with the aid of an electronic detector.
  • Page 3 PARTS SUPPLIED LIST Tap Body & Valve 1 SETS Hose Connecter 1 PCS Filter Washer 2 PCS Left Inlet leg 1 PCS Right Inlet leg 1 PCS Rubber Washer 4 PCS Fixing Nut 2 PCS Wall Bracket 1 PCS Shower Hose 1 PCS Handset 1 PCS...
  • Page 4 HOW TO INSTALL BEFORE YOU START This product must be connected to the water supply in accordance with the Water Supply (Water Fittings) Regulations 1999, and also to comply with UK Building Regulations. If you are in any doubt about these requirements, contact a qualified plumber, your local Water Company or the Water Regulations Advisory Service (WRAS).
  • Page 5 11. Finally turn on all the water heating arrangements. 12. Assemble the handset(10) to Shower Hose(9) using Rubber Washer(prvided in the pack). DO NOT OVERTIGHTEN. (10) Please note: Tap heads shown is for illustration purposes only.
  • Page 6 GENERAL CHARACTERISTICS The valve is suitable for all water heating systems provided it is installed correctly by a competent and qualified installer. OPERATING SPECIFICATIONS WATER SUPPLY TEMPERATURE: Hot Water Maximum: 70˚C Recommended 60-65˚C Cold Water Minimum: 5˚C Higher than maximum required mixed temperature. Advisable 65˚C Minimum difference between hot and mixed temperature is 10˚C OPERATING PRESSURE...
  • Page 7 TEMPERATURE SETTING (To be done only when essential) This mixer has been set in the factory under balanced pressures at 38˚C. Where conditions are different from the above the temperature of the mixed water may vary from setting. You can adjust the calibration of the mixer to suit individual requirements.
  • Page 8 If the cloth used to clean the tap has previously been used with a cleaner that contains bleach , take special care to thoroughly rinse the cloth with clean water before use. Wickes Building Supplies LTD Lodge Way House, Lodge Way Harlestone Road Northampton NN5 7UG W INST 300 (Rev. 1.1) Customer service number :01604 663607...