Advertisement
-Fitting the Shower Kit
1. Mark and drill 2 holes (the centre of two holes
532±3mm) on the wall, ensure that the shower
hose(19) will not be over extended when the
slider(21) is in its highest position.
2. Once holes are drilled , insert wall plugs(16) to wall.
3. Fit upper riser rail bracket(23) to the wall using the
short wall screw(22).
4. Press the button of the slider and push it to the riser
rail(18).
5. Fit hose retainer(17) to riser rail(18), then fit lower
riser rail bracket(15) to riser rail(18).
Note: The large hole in the riser rail must be facing
forward the installer.
6. Fit this assembly to upper riser rail bracket(21)
through the hole of the upper riser rail bracket.
Tighten the lower riser rail bracket(15) using the long
wall screws(14).
are
16
23
22
7
Bottom
diagram
21
18
18
21
17
15
14
Advertisement
