NRA737880 Issue E
5.6
Fault Finding
The AIM Gauge has self-monitoring fault detection circuits which close an error output signal when the gauge is not
operating correctly. You can use the error signal output to determine if a fault has been detected, as described in
Section
4.4.
If the AIM Gauge does not operate correctly, ensure that the electrical connections are correct (refer to
Section
3)
and ensure that your electrical supply is suitable for the AIM Gauge (refer to
Section
2).
Page 16
© Edwards Limited 2020. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.