Surface-Mounted Installation - Miele KM 7999 FR Operating And Installation Instructions

Surface-mounted installation

 Create the worktop cut-out. Remem-
ber to maintain the minimum safety
distances (see "Installation – Safety
distances").
 Seal any cut surfaces on wooden
worktops with a special varnish, sil-
icone sealant or resin to prevent the
wood from swelling as a result of
moisture ingress. The sealant must
be heat-resistant.
Make sure that the sealant does not
come into contact with the top of the
worktop.
 Stick the supplied sealing strip under
the edge of the hob. Do not apply the
sealing strip under tension.
 Feed the mains connection cable
down through the cut-out in the hob.
 Place the hob centrally in the cut-out.
When doing this, make sure that the
seal of the appliance sits flush with
the worktop on all sides. This is im-
portant to ensure an effective seal all
round.
Do not use any additional sealant
(e.g. silicone) on the hob.
If the seal does not sit flush with the
worktop in the corners, the corner ra-
dius (≤ R4) can be carefully cut to fit
using a jigsaw.
 Connect the hob to the power supply.
 Check that the hob works.
Installation
77