Advertisement
5-10-3. Crossover setting-LINK setting combined with SEPARATE setting
Performing the SEPARATE setting after LINK setting
In LINK setting, the lowest band signal is output to CH-A, and higher band signals are
output in the order of CH-B, CH-C, CH-D. Therefore, output connectors of the rear panel
should be connected beforehand accordingly.
In LINK setting, after setting the basic crossover, press the SEPARATE (F7) key more than
two seconds to shift to SEPARATE setting. Operations can be continued from the crossover
state set by LINK setting. Detailed settings can therefore be performed in SEPARATE
setting after basic settings are performed in LINK setting.
Performing LINK setting after SEPARATE setting
Pressing LINK setting (F6) key in SEPARATE setting state for more than two seconds will
set LINK setting.
However, at this time, any settings in the SEPARATE setting are set to the following states
forcibly, and all parameters set by SEPARATE setting will be canceled.
Point A-B frequency
: 250 Hz
Point B-C frequency
: 1.6 kHz
Point C-D frequency
: 10 kHz
Filter characteristics
: Butterworth —12 dB/oct
When shifting from SEPARATE setting to LINK setting, all output MUTE switches will be
turned ON to mute outputs.
31
Advertisement
