Advertisement
5-10-1. Crossover setting-LINK setting
Allocation of signal frequency band to four output channels A, B, C, and D.
In LINK setting, the lowest band signal is output to output CH-A, and higher band signals
are output in the order of CH-B, CH-C, CH-D. Therefore, output connectors of the rear
panel should be connected beforehand accordingly.
Functions of the LINK setting function keys and parameter setting knobs
Select points to be set of the three cross points (A-B, B-C, or C-D) using F1, F2, or F3 key,
then set parameters of the crossover filters using the P2 and P3 knobs.
POINT A-B (F1)
_: Sets the cross point of output channel A and output channel B.
(POINT A-B means the cross point of output channel A and out
put channel B.)
POINT B-C (F2)
__: Sets the cross point of output channel B and output channel C.
POINT C-D (F3)
_: Sets the cross point of output channel C and output channel D.
FREQ (P2)
: The crossover filter cut-off frequency 20 Hz to 20 kHz (1/6 oct
steps)
TYPE (P3)
: Selects the filter characteristics.
Reference
e The POINT A-B frequency can not be set higher than the point B-C frequency.
¢ The POINT B-C frequency can not be set higher than the point C-D frequency.
EXIT (F10)
Pressing the EXIT (F10) key returns to the main menu from the crossover setting menu.
29
Advertisement
