Advertisement
26
Enables to set a delay time for four output channels independently.
In order to set minute time alignment in the crossover mode (modes A to D), delays ranging
from 10.4 psec to 30 msec (in steps of 10.4 [usec) can be set for each channel.
Functions of function keys and parameter setting knobs
Other key functions
Set a desired channel 'from the four channels using any of F1 to F4 keys, then set
the delay time of the selected channel using the parameter knob.
CH-A (F1)
: Sets output channel A.
CH-B (F2)
: Sets output channel B.
CH-C (F3)
: Sets output channel C.
CH-D (F4)
: Sets output channel D.
x 100 step (P2): Increases/decreases the delay time in steps of 100 (=1.04 msec) for each
rotation of the knob.
x 10 step (P3)
: Increases/decreases the delay time in steps of 10 (=104 usec) for each
rotation of the knob.
x 1step (P4)
: Increases/decreases the delay time in steps of 1 (=10.4 usec) for each
rotation of the knob.
e Values are displayed in sec on the screen.
e Any delay time can be set by the combination of the three knobs.
(Example of screen where output channel B is being set)
ON/OFF (F6/F7)
The ON/OFF (F6/F7) keys are used to set all the channel delay functions ON/OFF.
When ON (F6) is pressed, the channel delay function operates.
When OFF (F7) is pressed, the signal will pass through the processing block without the
channel delay function operating.
Even when set to OFF, parameter settings will be preserved, and settings can be performed
while viewing parameter values.
EXIT (F10)
Press the EXIT (F10) key to return to the main menu from the channel delay setting menu.
Advertisement
