Advertisement
6-3.
Connect the cable of the internal simple UPS (a power cable and two signal cables) to the
CN104, CN105 and CN103 connector of the control kit.
Motherboard's Jumper setting
7.
Important To avoid system malfunction, do not change other jumper setting.
Tips
The procedure of installing this product depends on your server type.
Please work with a procedure of the sever you're using.
[In case of Express5800/T110i-S]
The jumper on motherboard must be configured when using internal simple UPS. When using N8181-
152 internal simple UPS, set jumper (BIOS OR) on the motherboard to "Enabled" (Set to 2-3).
If N8181-152 internal simple UPS is not used, set jumper (BIOS OR) on the motherboard to "Disabled"
(Set to 1-2).
Enabled
Disabled
BIOS OR
Jumper
CN104 Connector
CN105 Connector
Rear Side
Motherboard
Front Side
19
CN103 Connector
Power Connector
Power Connector
I2C Connector
Advertisement
