Advertisement
FRAME ASSEMBLY
I
1.
Make sure that you unde_mnd a|! of the
infonmdion on page 5 before you begin
assembling the weight system.
Locate and open the parts bags labeled "FRAME
ASSEMBLY 1" and "FRAME ASSEMBLY 2."
Press a 2" Square Inner Cap (105) into the open
end of the Long Base (120).
Insert eight 5/16" x 2 112"Carriage Bolts(110) up
through the Long Base (120) and the Short Base (2)
as shown. Note: It may be helpful to place tape
over the heads of the Carriage Bolts to hold
them in place.
Attach the Short Base (2) to the Long Base (120)
with two 5/16" x 2 3/4" Bolts (85), the Long Frame
Plate (71), and two 5116"Nylon Locknuts(86).
2.
Attach the Outer Cap (24) to the Short Base (2)
with two #8 x 314"Screws (98).
Press two 2" x 3" Inner Caps (58) into the Foot
Plate (53). Attach the Foot Plate to the Long Base
(120) with two 5/16" x 2 112"Carnage Bolts (110)
and two 5/16" Nylon Locknuts (86)
3.
Attach the tether on the Pin (112) to the Long Base
(120) with a #10 x 1" Screw (14).
Attach the four Knee Rest Bumpers (123) to the
Squat Knee Rest (41) with four #10 x 1" Bcrews
(14) Attach the Squat Knee Rest to the Long Base
(120) with a 3/8" x 3 1/4" Bolt (96) and a 3/8" Nylon
Locknut (87) Do not overtightan the Nylon
Locknut; the Squat Knee Rest must be able to
pivot.
3
110
110
58
71
85
120
86
110
110
1
120
86
24
41
6
Advertisement
