Table of Contents
Advertisement
TYRE PRESSURE LOSS WARNING
This function is an
additional driving aid.
The function does not
take the place of the
driver. It cannot, therefore, under
any circumstances replace the
vigilance or the responsibility of
the driver.
Check the tyre pressures,
including the emergency spare
wheel, once a month.
Resetting the standard level for the
tyre pressures
It must be carried out while the
vehicle is stopped :
– after each reinflation or readjustment
of the pressure of one of the tyres ;
– when the standard tyre pressure
needs to be changed to adapt to
usage conditions (empty, carrying a
load, motorway driving, etc.) ;
– after changing a wheel ;
– after using the tyre inflation kit ;
– after switching the wheels of the
same axle (you must not switch
between the front and rear wheels).
It should always be done after
checking the tyre pressure of all four
tyres when cold.
Resetting procedure
Ignition on, vehicle stationary:
– press button B briefly several times
to select the function " SET TYRE
PRESSURE " is displayed ON the
Instrument panel.
– press and hold (around 3 seconds)
button B to start initialisation. If the
"SET
" warning light flashes or
text message on the Instrument panel
"TPMS ONGOING " for approximately
5 seconds accompanied by a constant
illumination of the SET
light, this indicates that the request for
reinitialisation of the tyre pressure
reference value has been correctly
registered.
Reinitialisation is carried out after a
few minutes' driving.
Resetting procedure
(depending on vehicle)
Ignition on, vehicle stationary:
– press button A briefly several times
to select the function " TYRE
PRESSURE SET " is displayed ON the
Instrument panel.
– press and hold OK switch B (around
3 seconds) to start initialization. Then
confirm " RESET " tyre pressure
message will appear. Select OK to
warning
reset the tyre pressure. If
warning light along with
turned off. This indicates that the
3
are
D r i v i n g - 8 1
Advertisement
Table of Contents
