Table of Contents
Advertisement
© Panduit Corp. 2022
Wrinkle Problem
RTC Time is Incorrect
When Rebooting the
Printer
The Left/Right Side
Printout Position is
incorrect
The Top/Bottom Printout
Position is incorrect
6.
Maintenance
This session presents the methods to maintain your printer.
• For Cleaning
Depending on the media used, the printer may accumulate residues (media dust, adhesives,
etc.) as a by-product of normal printing. To maintain the best printing quality, you should
remove these residues by cleaning the printer periodically. Regularly clean the print head and
supply sensors once you change to a new media to keep the printer at the optimized
performance and extend printer life.
• For Disinfecting
Sanitize your printer to protect yourself and others and can help prevent the spread of viruses.
• Important
-
Set the printer power switch to O (Off) prior to performing any cleaning or disinfecting
tasks. Leave the power cord connected to keep the printer grounded and to reduce the risk
of electrostatic damage.
-
Do not wear rings or other metallic objects while cleaning any interior area of the printer.
-
Use only the cleaning agents recommended in this document. Use of other agents may
damage the printer and void its warranty.
-
Do not spray or drip liquid cleaning solutions directly into the printer. Apply the solution on
a clean lint-free cloth and then apply the dampened cloth to the printer.
B20733-02
USER MANUAL
•
Printhead pressure is
incorrect.
•
Ribbon installation is
incorrect.
•
Media installation is
incorrect.
•
Print density is
incorrect.
•
Media feeding in
incorrect.
•
The battery has run
down.
•
Wrong label size
setup.
•
The parameter Shift
X in LCD menu is
incorrect.
•
Wrong label size
setup.
•
The parameter Shift
Y in LCD menu is
incorrect
Page 37 of 39
•
Please set the suitable density to have
good print quality.
•
Make sure the label guide touches the
edge of the media guide.
•
Check if there is a battery on the main
board.
•
Set the correct label size.
•
Press [MENU] → [Setting] → [Shift X]
to fine tune the parameter of Shift X.
•
Set the correct label size.
•
Press [MENU] → [Setting] → [Shift Y]
to fine tune the parameter of Shift Y.
TDP43HET, TDP43HET/E,
TDP46HET,TDP46HET/E
08-2022
Advertisement
Table of Contents
