GD Rapter RR BC 20-42.7 Original Owner's Manual page 8

machine's guard. Serious injury to the operator or bystanders could result as
well as damage to the machine.
• Inspect the area to be cut and remove all debris that could become entangled
in the nylon cutting head. Also remove any objects that the unit may throw
during cutting.
• Keep children away. Onlookers should be kept at a safe distance from the work
area, at least 15 METER (50 FEET)
• Never leave the machine unattended.
• Do not use this unit for any job other than those for which it is intended as
described in this manual.
• Do not overreach. Keep proper footing and balance at all times. Do not run the
unit while standing on a ladder or on any other unstable footing location.
• Keep hands and feet clear of the nylon cutting head while unit is in use .
• Do not use this type of machine for sweeping away debris.
• Do not use the unit when you are tired, ill or under the influence of medication,
drugs or alcohol.
• Use nylon cutting head which is free of damage. If a stone or any other obstacle
is hit, stop the engine and check the nylon cutting head. A broken or unbalanced
nylon cutting head must never be used.
FOLLOW INSTRUCTION FOR CHANGING ACCESSORIES.
• Do not store in a closed area where fuel vapors can reach an open flame from
hot water heaters, heaters, furnaces, etc. Store in a locked, well ventilated area
only.
• Еnsure safe and proper performance of your product. These parts are available
from your dealer. The use of any other accessories or attachments may cause
a potential hazard or injury to the user, damage to the machine and void this
warranty.
• Clean the machine completely, especially, the fuel tank, its surroundings, and
the air cleaner.
• When refueling, be sure to stop the engine and confirm that it is cooled down.
Never refuel when the engine is running or hot. When gasoline spills, be sure to
wipe it up completely and properly dispose of those materials before starting
the engine.
• Stay clear of other workers or bystanders by at least 15 meters /50 feet.
• Whenever approaching an operator of the machine, carefully call his attention
and confirm that the operator stops the engine. Be careful not to startle or
distract the operator which can cause an unsafe situation.
• Never touch the nylon cutting head whenever the engine is running. If it is
8