Cutting With A Nylon Head - GD Rapter RR BC 20-42.7 Original Owner's Manual

CUT-OFF KNIFE
ON LEFT SIDE
CUT-OFF KNIFE
ON LEFT SIDE
WARNING
Line head rotates in a CLOCKWISE direction.
DO NOT TOUCH THESE TYPES OF
The CUT-OFF KNIFE will be on the right side of
OBJECTS WITH BLADE
WARNING
the debris shield.
DO NOT TOUCH THESE TYPES OF
METAL STAKES
OBJECTS WITH BLADE
UTILITY WIRES
METAL STAKES
MASONRY
ROCKS
UTILITY WIRES
ROCKS
COUNTER CLOCK WISE ROTATION
16

CUTTING WITH A NYLON HEAD

DANGER
DANGER
RUBBER
RUBBER
MASONRY
FENCES
CUT ON
THIS SIDE
OIL-1 PART
FENCES
GASLINE
25 PART
OIL-1 PART
GASLINE
25 PART
WARNING
The proper debris shield must be in place
on the unit when nylon cutting line is used.
The cutting line can flap around if too much
line is exposed. Always use the plastic debri
shield with cut-off knife when using nylon
cutting heads.
For nearly all cutting, it is good to tilt the line COUNTER CLOCK WISE ROTATION
head so that contact is made on the part
of the line circle where the line is moving
AWAY from you and the debris shield. (See
COUNTER CLOCK WISE ROTATION
appropriate picture) .This results in the
debris being thrown AWAY from you.
WARNING
TRIMMING
Use only quality nylon monofilament line of
the diameter 2.5mm. Never use wire or wire
reinforced line in place of nylon trimmer line.
KNIFE SIDE
Load your nylon line cutting head only with
RAISED
nylon trimmer line of the proper diameter.
ANGLE TO
GROUND
WARNING
Use extreme caution when operating over
bare spots and gravel, because the line can
throw small rock particles at high speeds.
Debris shields on the unit cannot stop
objects which bounce or ricochet off hard
surfaces.
INSTALLING BLADE GUARD
CAUTION
CUT ON
THIS SIDE
CUT ON
THIS SIDE
CAUTION
DEBRIS
BLADE
ANGLE
GUARD
TO WALL
Max Speed CAUTION
10000r/min
BLADE
GUARD
Max Speed
10000r/min
BLADE
SCALPING