Operations - GD Rapter RR BC 20-42.7 Original Owner's Manual

ENGINE STARTING AND STOPPING PROCEDURES
STARTING COLD ENGINE
1. Move the stop switch to „START" position.
2. Give a gentle push on the primer pump
repeatedly (7-10times) until fuel comes into
the primer pump.
3. Cold Starts: Pull lever up to close choke.
4. Pull starter handle until engine false fires.
5. Push choke lever inwards (excessive
cranking with choke lever will cause flooding
engine making it difficult to start.)
6. Pull starter handle until engine starts.
7. Allow engine to warm up for a few
minutes before using.
22
STARTING WARM ENGINE
• If fuel tank was not run dry, pull starter one
to three times and engine should start.
DO NOT USE CHOKE
• If fuel tank was run dry, after refilling repeat
steps 3 thru 7 in STARTING COLD ENGINE.
STOPPING THE ENGINE
• Move switch to STOP position.