Fuel & Oil Mixture - GD Rapter RR BC 20-42.7 Original Owner's Manual

CUT-OFF KNIFE
ON LEFT SIDE
DANGER
OBJECTS WITH BLADE
WARNING!
Fuel used for this model is a mixture of unleaded gasoline and approved engine lubricant.
METAL STAKES
When mixing gasoline with two-cycle engine oil, use only gasoline which contains NO
ETHANOL or METHANOL (Types of Alcohol) Use Branded 89 octane or higher unleaded
gasoline known to be of good quality. This will help to avoid possible damage to engine fuel
lines and other engine parts.
MASONRY
FUEL
The engine uses two-stroke fuel, a mixture
of gasoline and 2-stroke lubricant 25:1
GASOLINE
Use branded 89 octane or higher unleaded
gasoline known to be of good quality.
STORING FUEL
Store fuel only in a clean, safe, aprroved
ontainer. Check and follow local
ordinances on type and location of
storage container.
20
COUNTER CLOCK WISE ROTATION
FUEL AND OIL MIXTURES
• Never fill the fuel tank to the very top.
• Never add fuel to the tank in a closed non-ventilated area.
• Do not add fuel to this unit close to an open fire or sparks.
• Be sure to wipe off spilled fuel before attempting to start engine.
• Do not attempt to refuel a hot engine.
RUBBER
MIXTURE RATIO IS 25:1 - GASLINE-25 PART, OIL-1 PART
FENCES
OIL-1 PART
GASLINE
25 PART
FENCES
OIL-1 PART
GASLINE
25 PART
Fuel mixture at the rate
other than 25:1 may cause
damage to the engine,
Ensure mixture
ratio is correct.
INSTALLING BLADE GUARD
IMPORTANT
Two-stroke fuel may separate.Shake fuel
container thoroughly before each use.
Stored fuel ages. Do not mix more fuel than
you expect to use within a month.
FUEL AND OIL MIXTURE
Inspect fuel tank making sure that it is clean
and fill with fresh fuel. Use a mixture of 25-1.
Two-stroke oil
• For the best results use high level
• Never use oil intended of four-stro
BLADE
GUARD
Max Speed
10000r/min
Mixture
BLADE
• Always mix petrol and oil in a clea
• Always start by filling half the quan
re. Fill the remaining quantity of pet
• Mix (shake) the fuel mixture carefu
• Do not mix more than max. one m
• If the brush cutter is not used for a
Fuelling
WARNING!
The following precautions reduce th
Do not smoke or place any sources
stop the engine and let it cool for a f
over pressure is released slowly. Ti
fuelling place before starting.
Clean around the fuel cap. Contami
Ensure that the fuel is well mixed by
Always use a fuel container with an
INSTALLI
AVOI