Safety Rules & Precautions - GD Rapter RR BC 20-42.7 Original Owner's Manual

SAFETY RULES & PRECAUTIONS
Because a trimmer/cutter is a high-speed, fast cutting power tool, special safety
precaution must be observed to reduce the risk of personal injury. Read this
manual carefully. Be familiar with the controls and the proper use of the unit.
Know how to shut it off, and how to unhook a harnessed unit quickly.
Proper safety precautions must be observed. Like all power equipment this unit
must be handled carefully. Do not expose yourself or others to danger follow
these general rules. Do not permit others to use this machine unless they are
thoroughly responsible and have read, and understand the machine manual
and are trained in its operation.
• Always wear safety goggles for eye protection. Dress properly; do not wear
loose clothing or jewelry that could become caught in moving parts of the unit.
Safe, sturdy, nonskid footwear should always be worn. Long hair should be tied
back. It is recommended that legs and feet be covered to protect from flying
debris during operation.
• Inspect the entire machine for loose parts (nuts, bolts, screws, etc.) and any
damage. Repair or replace as necessary before using the machine.
• DO NOT USE any attachment with this power head other than the ones
recommended by our company. Serious injury to the operator or bystanders
could result as well as damage to the machine.
• Keep the handles free from oil and fuel.
• Always use proper handles and shoulder strap when cutting.
• Do not smoke while mixing fuel or filling tank.
• Do not mix fuel in an enclosed room or near open flames. Assure adequate
ventilation.
• Always mix and store the fuel in a properly marked container that is approved
by local codes and ordinances for such usage.
• Never remove the fuel tank cap while the engine is running.
• Never start or run the engage inside a closed room or building. Fumes from
the exhaust contain dangerous carbon monoxide.
• Never attempt to make engine adjustments while the unit is running and
strapped to the operator. Always make engine adjustments with the unit resting
on a flat, clear surface.
• Do not use the unit if it is damaged or poorly adjusted. Never remove the
7