General - Sony GRAND WEGA KDF-E42A10 Operating Instructions Manual

Other Information
General
How to reset TV to Ii_ctory _ Turn on the TV. While holding down the t button on the remote control, press the
settings POWER button on the TV. (The TV will turn itself off, then back on again.)
Release the t button.
WARNING: The Factory Reset will clear all of your customized settings
including Parental lock setting.
How to restore Video settings _ Select Reset setting option while in the Video setting (see page 66).
to Ii/ctory settings
How to restore Audio settings _ Select Reset setting option while in the Audio setting (see page 66).
to factory settings
Cannot cycle through the other _ Be sure the Label Video
Inputs
option is not set to Skip (see page 79).
video equipment connected to
the TV
Cannot operate the setting _ If a setting option appears in gray, this indicates that the setting option is not
available.
Lost password _ On the password screen (see page 74), enter the following master password:
4:357. The master password clears your previous password; it cannot be used to
temporarily unblock channels.
TIMER LED on front panel is _ When lit, indicates that the timer is set (see page 83). When the timer is set, this
lit LED will remain lit even when the TV is turned off.
LAMP LED blinks in red _ Replace the !!}111p (see puge 86). ...................
Digital cable box does not work _ If you are connecting a VCR and digital cable box using a splitter, as described on
page .35, you must use a special bi-directioual splitter that is designed to work
with your digital cable box. Contact your cable provider for details.
Cannot record digital channels _ Only analog channels can be recorded to your VCR.
to VCR
TV cabinet creaks _ When the TV is in use, there is a natural rise in temperature, causing the cabinet to
expand or contract and may be accompanied by a slight creaking noise. This is not
a malfunction.
A slight creaking noise occurs _ Advanced Iris applies a mechanical iris system. When Advanced Iris is set, a
from the bottom part of the TV natural creaking noise occurs due to the basic structure of the optical unit. The
cre_tking sound is an inherent nature of this system and is not a defect.
The cooling f.n is ioud _ if ihe TV is ;;seciai high _,iiiiiicies ; _n_i High Aiiiiud; is sei io 6nl ihe cooiin_ f_,n
runs faster and its sound becomes louder. If the TV is not used at high altitndes,
set High Altitude to Off (see page 81).
"High Temperature Warning!" _ Make sure to remove (lust from the ventilation slots on the rear and both sides of
message appears the TV. In addition, make sure that there are no obstacles in front of the ventilation
slots. If the message still appears aller the dust or obstacles are removed, the TV
may need servicing. Call your local Sony, Service Center.
The TV does n0i turn on a The
TV cools d0;,n its
projection lmnp when the power is turned oft'. It takes Up to
two minutes for the picture to come back after the TV is turned on again. Wait for
a while until the picture comes back.
O
o
93