Vcr And Cable Box - Sony GRAND WEGA KDF-E42A10 Operating Instructions Manual

Connecting the TV
VCR and Cable Box
Use this hookup if:
[] Your cable TV company scrambles some channels, but not all of them
(pay channels vs. regular cable channels) and you need to use a cable
box.
With this connection you can:
[] Use tile TV's relnote control to change channels on your cable box
when the signal is scralnbled. To program your Sony remote control to o_
operate your cable box, see "Programming tile Remote Control" on
page 47.
[] Use tile TV's remote control to change channels on your TV when tile _"
signal is not scrambled. Your TV's tuner provides a better picture ._
quality than tile output of your cable box. r= "..I
Disconnect all power sources before making any connections.
t Connect tile CATV cable to tile single (input) jack of tile splitter.
2 Use a coaxial cable to connect one of the output jack of the splitter to
the TV's CABLE jack.
;3 Use a coaxial cable to connect tile splitter's other output jack to tile
cable box's input jack.
4 Use a coaxial cable to connect the cable box's output jack to the VCR's
RF input jack.
5 Use an A/V cable to connect tile cable box's A/V output jacks to tile
TV's A/V input jacks.
6 Use an A/V and S VIDEO cables to connect tile VCR's AUDIO and S
VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks.
L_ If your VCR is not equipped with S VIDEO, use a VIDEO Cable
(yellow) instead of the S VIDEO cable.
7 Run Initial Setup, as described in "Setting Up tile Channel List" on page
32.
Y_ To view scrambled Channels. tune the TV to the channel the Cable
box is set to (usually channel 3 or 4) and then use the cable box to
switch channels.
(Continued)
35