Mounting - Uwatec DC-12 Owner's Manual

A The DC-12 has a practical and convenient dive.planner feature.
You can simulate any dive profile in advance, considering any
residual nitrogen retained in memory. The planner runs 12 times
faster than real time so the dive can be simulated quickly.
A If submerged, the DC-12 is automatically switched on by water
sensing contacts. You can manually switch on the instrument by
bridging the contacts with wet fingertips.
A The DC-12 will display the air temperature on the surface.
A Vital information about no-stop decompression times and ascent
rate are displayed in both digital and graphic format. This makes the
computer easier to use and understand at a glance.
II. MOUNTING
CONSOLE
The DC-12 capsule can be mounted, by means of an adapter into
the Scubapro V.I.P. 3-gauge console for hands free operation. See your
Scubapro dealer for assistance.
NOTE
If the DC-12 is fitted into any other manufacturers console, it must allow
unobstructed water flow to the back of the DC-12 to sense water
pressure.
WRIST MOUNT
For wrist mounting, the DC-12 can be fitted to the Scubapro wrist
strap. To install, the strap should be soaked in hot water for a few minutes
to make it pliable, then insert the DC-12 into the strap from the bottom.
2
To tighten the strap, push against the strap lock with your thumb
and pull the strap tight. Release the strap lock so it engages one of the
slots in the strap. It may be necessary to retighten the strap at depth
during the dive.
1. push
2. pull
Figure 1a
To loosen, press the strap lock and pull outthe strap enough to slide
the strap over your hand.
1. push
2. pull
Figure 1 b
3