Table of Contents
Advertisement
Arizona 1300 XT printers
Ink Enclosure is stacked on the Gantry Crate
IMPORTANT
The XT gantry crate must not be tilted more than 15 degrees! Try to keep it level at all times.
XT Table Crates
IMPORTANT
Arizona 1300 XT table crates are designed to be stacked. Make sure they are stacked as shown in
the figure above. Do not tilt the table crates when they are stacked. If the crates are not stacked
they can be tilted up to 45 degrees, but it is still best to keep them level.
Facility Requirements XT
To install the printer, the customer's facility should meet the following requirement:
Hallway width (Minimum): 1.41m (55.5") - This allows for approximately 75mm or 3" of total
clearance.
Chapter 3 - Shipping & Handling
23
Advertisement
Table of Contents
