Advertisement
3.1
Precautions for Disassembly
3.1.1 Removing the Case Assy
(1) Unlock the two slide lock levers on the COVER <1>, then
remove the cover using coin as shown in the figure. <2>.
(2) Remove the six special screws.
(3) Remove the rear case from the front case.
Note:
When reassembling, follow "3.2.13 screw tightening
procedure of the case", and tighten the screws of the
case in the correct order.
Battery pack
COVER
<2>
<1>
Rear case
Front case
3.1.2 Remving of the TX-RX unit
(1) Remove the volume knob and related parts.
(2) Remove the antenna terminal soldering.
(3) Remove the soldering of speaker lead wires.
(4) Remove the screw fixing the frame.
(2)
Battery terminals
SECTION 3
DISASSEMBLY
Lock lever
(1)
Frame
(3)
(4)
Charging terminals
(5) Lift up the TX-RX unit from its bottom side, then remove it.
Note:
At this time, lift the TX-RX unit while expanding the
side of the case to the outside so that the TX-RX unit
does not interfere with the holder of the side key.
(When reassembling, be careful not to interfere with
the holder of the side key in the same way.)
Holder of the side key
Note:
When removing the TX-RX unit, be careful not to
contaminate the battery terminals, charging terminals
of the TX-RX unit or to damage them.
Area to push the case
TX-RX unit
Push the case to spread out
Lift up the TX-RX unit
(No.RA066<Rev.001>)1-15
Advertisement
