Engine Service Cover; Gauge - SeaDoo GTX Series 2022 Shop Manual

Section 07 BODY AND HULL
Subsection 01 (BODY)
219100893-032-732_a
Remove cleat.
NOTE: There are nuts and washers inside the
hull. Be careful not to lose them in the hull.
Storage compartment can be removed fo easy
access.
Installing the Cleat
The installation is the reverse of the removal pro-
cedure. However pay attention to the following.
TIGHTENING TORQUE
Cleat screw

ENGINE SERVICE COVER

219100893-032-718_a
Removing the Engine Service Cover
1. Remove seats.
2. Remove wake pole cover.
228
2.75 N•m ± 0.25 N•m
(24 lbf•in ± 2 lbf•in)
219100893-032-720_a
3. Remove screws.
219100893-032-719_a
Installing the Engine Service Cover
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Install all screws.
Tighten screws to specification.
TIGHTENING TORQUE
Engine service cover
screw

GAUGE

Removing and Installing the Gauge
INFORMATION CENTER
Refer to
2.75 N•m ± 0.25 N•m
(24 lbf•in ± 2 lbf•in)
subsection.
219100963-021