Impeller Shaft, Bearing And Seals - SeaDoo GTX Series 2022 Shop Manual

Installing the Wear Ring
Like the removing procedure, two methods can
be used to install the wear ring, use the most ap-
propriate as your situation.
Method Using a Freezer
While the housing is still cold, insert the new wear
ring (previously placed in the freezer) in the hous-
ing.
On models equipped with the 300 engine, the
wear ring must be secured by screws. Drill pilot
holes in the wear ring using a #24 drill bit (5/32 in)
and apply blue Loctite on screw threads.
SERVICE PRODUCT
LOCTITE 243 (BLUE) (P/N 293 800 060)
TIGHTENING TORQUE
Wear ring screws
Method Using a Press
To install wear ring in housing, use a square steel
plate of approximately 180 x 180 mm x 6 mm thick
(7 x 7 in x 1/4 in) and a press.
Manually engage ring in housing making sure it is
equally inserted all around. Press ring until it seats
into bottom of housing.
1
2
F01J1DA
1. Rounded edge
2. Press wear ring
On models equipped with the 300 engine, the
wear ring must be secured by screws. Drill pilot
holes in the wear ring using a #24 drill bit (5/32 in)
and apply blue Loctite on screw threads.
219100963-019
Section 06 STEERING AND PROPULSION
2.5 N•m ± 0.5 N•m
(22 lbf•in ± 4 lbf•in)
Subsection 03 (JET PUMP)
SERVICE PRODUCTS
LOCTITE 243 (BLUE) (P/N 293 800 060)
TIGHTENING TORQUE
Wear ring screws
IMPELLER SHAFT, BEARING AND
SEALS
Removing the Impeller Shaft, Bearing
and Seals
Removing the Shaft
1. Remove impeller. Refer to
subsection.
2. Use the impeller shaft pusher tool to press im-
peller shaft out of pump housing.
REQUIRED TOOL
IMPELLER SHAFT
PUSHER (P/N 529
035 955)
NOTE: Bearing will come out with the impeller
shaft.
smr2009-006-010_a
TYPICAL
2.5 N•m ± 0.5 N•m
(22 lbf•in ± 4 lbf•in)
IMPELLER
in this
195