Fuel Filter; Fuel Level Sensor - SeaDoo GTX Series 2022 Shop Manual

5. Test the fuel tank for leaks. Refer to
FUEL TANK FOR LEAKS

FUEL FILTER

Inspecting the Fuel Filter
Inspect fuel filter. If dirty, partially clogged or dam-
aged, replace it.
smr2009-031-025_a
1. Fuel filter
Removing the Fuel Filter
NOTE: The lower fuel filter on the fuel pump mod-
ule does not require replacement under normal
operating conditions. Replace only if permanently
clogged or damaged.
1. Remove fuel pump. Refer to
this subsection.
WARNING
The upper filter and fuel pump reservoir on
the fuel pump module contain fuel which will
drain out when fuel pump module is not in an
upright position.
2. Turn fuel pump upside down.
3. Using a small flat screwdriver, pry up the filter
locking tabs.
219100893-021
Subsection 02 (FUEL TANK AND FUEL PUMP)
TESTING
.
FUEL PUMP
in
Section 04 FUEL SYSTEM
smr2008-022-013_a
1. Fuel filter locking tab (x2)
2. Filter locking pin (x2)
4. Pull filter off fuel pump reservoir housing.
Installing the Fuel Filter
1. Align new filter with pump reservoir housing.
2. Press new filter on by hand. Ensure it is fully
seated and locked onto the pump reservoir
housing.
3. Reinstall fuel pump as per procedure in this sub-
section.
4. Test the fuel tank for leaks. Refer to
FUEL TANK FOR LEAKS
5. Install all other removed parts, refer to applica-
ble subsection.

FUEL LEVEL SENSOR

Fuel Level System Overview
A float type fuel level sensor mounted on the fuel
pump module sends a signal to the information
center.
smr2008-022-007_b
TYPICAL — FUEL PUMP MODULE
1. Fuel level sensor
TESTING
.
97