Starter Solenoid - SeaDoo GTX Series 2022 Shop Manual

Disconnect connector "B" from the ECM, refer to
WIRING HARNESS AND CONNECTOR
tion.
Install ECM adapter tool on ECM harness connec-
tor "B".
Set the multimeter to .
Press and hold the START/STOP switch and test
for continuity of the switch circuit as per following
table.
CONTINUITY TEST OF START/STOP SWITCH
CIRCUIT (BUTTON PRESSED AND HELD)
ECM
FUSE BOX
CONNECTOR B
Pin E3 B-H2
2. If the reading is as specified, the START/STOP
switch and its wiring are good.
3. If a high resistance or an open circuit is mea-
sured, carry out TESTING THE START/STOP
SWITCH CONTINUITY
Testing the START/STOP Switch
Continuity
1. Remove START/STOP switch fuse (F10).
2. Disconnect the 20-pin steering harness connec-
tor:
219100893-025-001
1. 20-pin steering connector
3. Use the multimeter and select .
4. Measure resistance through switch as per fol-
lowing table.
219100963-014
subsec-
RESISTANCE
Close to 0
(continuity)
.
Section 05 ELECTRICAL SYSTEM
Subsection 04 (STARTING SYSTEM)
CONTINUITY TEST OF START/STOP
SWITCH CIRCUIT
DIAGNOSTIC
SWITCH
HARNESS
POSITION
CONNECTOR
Released
Pins 1 and 4
Pressed and
held
If the switch does not test as specified, replace
the engine START/STOP switch.
If the switch tests as specified, check for an open
circuit between connections as per table:
OPEN CIRCUIT TEST
CIRCUIT CONNECTIONS
Steering harness
Fuse box pin E3
connector pin 1
Steering ECM connector
connector pin 4 B, pin H2

STARTER SOLENOID

Starter Solenoid Location
219100893-025-002
Testing Solenoid Input Voltage
1. Make sure F11 fuse is powered and in good
condition before testing.
2. Disconnect solenoid connector.
RESISTANCE
Infinite (OL)
Close to 0
RESISTANCE
Must be close
to 0
131