Training; Preparation - Champion 500137-N Operator's Manual

500137-N - 3 iN. (7.6 cM) chiPPER ShREDDER
When operating the chipper-shredder:
– DO NOT move or tip the chipper-shredder during operation.
– DO NOT tip the chipper-shredder or allow fuel or oil to spill.
When transporting or servicing the chipper-shredder:
– Make certain that the fuel valve is in the OFF position and
the gasoline tank is empty.
– Disconnect the spark plug wire.
When storing the chipper-shredder:
– Store away from sparks, open flames, pilot lights, heat and
other sources of ignition.
– Do not store chipper-shredder or gasoline near furnaces,
water heaters, or any other appliances that produce heat or
have automatic ignitions.

NEVER use a gasoline container, gasoline tank, or any other
fuel item that is broken, cut, torn or damaged.

Training

1. Read the Operator's Manual completely before attempting to
use this chipper-shredder.
2. Do not allow anyone to operate your chipper-shredder
who has not read the Operator's Manual or has not been
instructed on the safe use of the chipper-shredder.
3. Never allow children or untrained adults to operate this
machine.
4. Many accidents occur when more than one (1) person
operates the chipper-shredder. If a helper is assisting, never
actuate controls until helper is clear of the area.
5. Never allow anyone to ride on the machine.
6. Never transport cargo on the chipper-shredder.
7. Projectiles can exit the chipper-shredder at high velocities.
To prevent injury, use the following instructions:
– Never operate the unit on asphalt or concrete.
– Never operate the unit close to any buildings or walls.
– Do not allow children, pets, bystanders, and assistants to
be within 75 ft. (22.9 m) of the unit during operation.
– Do not lean directly over any chute, entry or exit, during
operation.
– Keep the operator zone and adjacent area clear for safe,
secure footing.
WARNiNG
iMPORTANT SAfETY iNSTRUcTiONS
Although the chipper shredder contains a spark arrester,
maintain a minimum distance of 5 ft. (1.5 m) from dry
vegetation to prevent fires.
– Chipper-shredders should be used only for chipping
branches 3 in. (7.6 cm) or less in diameters or shredding
vegetation with small diameter branches. Do not use for
other purposes.
– Always make sure the spark plug wire is disconnected
from the engine when not in use, and before cleaning or
maintenance.

Preparation

1. Be thoroughly familiar with all controls and with proper use of
the equipment.
2. Make sure the spark plug wire is disconnected until
operation.
3. Safety Gear:
– Always wear safety shoes or heavy boots when operating
the machine.
– Always wear safety glasses or goggles when operating the
machine.
– Never wear jewelry or loose-fitting clothing that might
become entangled in moving or rotating parts of the
machine.
– Always wear hearing protection.
– Tie back long hair or anything that will dangle and may get
entangled.
4. Inspection:
– Make sure the spark plug wire has been fully removed and
the unit is grounded.
– Make sure the chutes, chambers, and intakes/exits are all
clean and free of any debris.
– Make sure the work area is clean and has no obstacles or
distractions.
– Make sure all connections and parts are secure and
undamaged.
– Make sure collection bag is fully connected and secured
when attached.
– Make sure material to be chipped is less than 3 in. (7.6 cm)
in diameter. Branches to be chipped can be pruned down.
– Make sure material to be chipped or shredded is not damp
or wet.
6
WARNiNG
