Table of Contents
Advertisement
500137-N - 3 iN. (7.6 cM) chiPPER ShREDDER
ASSEMbLY
Your chipper-shredder requires some assembly. This unit ships
from our factory without oil. It must be properly serviced with fuel
and oil before operation.
If you have any questions regarding the assembly of your chipper-
shredder, call our Technical Support Team . Please have your
serial number and model number available.
Unpacking
1. Set the shipping crate on a solid, flat surface
2. Carefully cut the shipping bands and remove lid of shipping
crate.
3. Locate all hardware before beginning assembly.
1) install the Shredder chute
1. Align the holes in the upper shredder chute (D) with the holes
in the lower shredder chute (E). (I)
i
2. Insert M6x15 bolt (C) into the hole of the chutes, from top to
bottom direction. (II)
3. Secure bolt with washer (A) and lock nut (B).
4. Tighten till secure. Do not over tighten.
5. Repeat step 2-4 for all holes in the chutes.
Make sure chutes are fully secured with all the holes aligned
and filled with bolts. If parts are damaged or missing do not
use the unit until replacement parts have been obtained.
ii
D
C
A
B
E
NOTicE
2) install the handle
1. Insert handle (A) into the brackets on the lower shredder
chute.
2. Secure the handle with the M8x35 bolt (C), lock washer (D)
and washer (B), and then through the handle on each side.
Handle has a threaded and unthreaded hole on each end.
Threaded hole goes on the hopper side. This will allow the bolt
to tighten properly when assembled.
3. Tighten until secure. Do not over tighten.
Threaded hole
Unthreaded hole
A
B
C
D
3) install the chipper chute
1. Remove bolt used to secure the support bracket to chute.
Only remove bolt, leave bracket in position.
2. Line up the upper chipper chute (A) with the rubber blocker
(C), and with the lower chipper chute (F). (I)
3. Once aligned, insert bolt (qty. 4) M6x20 (B) and bolt (qty. 1)
M6x25 (G) through the hole in the upper and lower chipper
chute (Being sure to re-attach support bracket to chute
assembly). Insert bolt from top to bottom direction. (II)
4. Secure bolt with washer (D) and lock nut (E). (II)
5. Tighten till secure. Do not over tighten.
6. Repeat step 2-4 for all holes in the chutes.
11
ASSEMbLY
NOTicE
Handle
NOTicE
Advertisement
Table of Contents
