Table of Contents
Advertisement
500137-N - 3 iN. (7.6 cM) chiPPER ShREDDER
Pulling the recoil cord will spin the impeller and this will make
noises. These noises are normal and should be made as the
cord is pulled and the impeller spins.
chipper-Shredder Operation
This machine has rotating blades and parts capable of
amputating body parts. This machine can also throw objects
at high velocity and long distances. Exercise extreme caution
when operating the chipper-shredder. NEVER insert body parts
or foreign object into any chute at any time. Never look directly
into any chute, as projectiles can backfire.
1. ALWAYS wear ear and eye protection, protective shoes and
clothing.
2. Block tires and put both support mounts in the DOWN
position to prevent unintended movement of the chipper-
shredder during operation.
3. Tie back long hair. Do not wear loose fitting clothing or
jewelry.
4. Make sure surrounding and immediate and safe zones are
clear of distractions and debris.
5. Do not attempt to chip or shred material that is larger than
specified. This may damage the unit or cause injury.
6. Make sure the materials that are going to be chipped or
shredded are free of any rocks, trash, metals and other
foreign objects.
7. Make sure wood to be chipped has been "trimmed" down
and do not have any excessive branches.
8. Make sure wood to be chipped or leaves/brush to be
shredded are not "wet" as this may clog the chutes.
9. Keep all chutes, deflectors and guards assembled and in
place at all times.
NOTicE
DANGER
If the impeller or blades strike a foreign object, stop engine
immediately. Do not continue use until chutes and unit have
been thoroughly inspected. Do not attempt to unclog any jam
or chute while engine is on or spark plug wire is connected.
ALWAYS use the chipper-shredder for its intended uses only.
The chipper-shredder should only be used to chip branches
3 in. (7.6 cm) or less in diameter, or to shred leaves and brush.
DO NOT chip anything that is larger than 3 in. (7.6 cm) in
diameter.
NEVER modify, alter or change the chipper-shredder design in
anyway. Unauthorized modifications will void the warranty and
may result in damage or injury.
DO NOT modify or change the engine and operating speeds.
Making these unauthorized changes is a Federal violation,
will void your warranty and will create safety performance
conditions.
ONLY operate the chipper-shredder in daylight.
NEVER operate, or let anyone else operate, the chipper-
shredder while under the influence of alcohol, drugs, or
medication.
NEVER leave the chipper-shredder unattended while the
engine is running. Avoid contact with the muffler, as it can
cause serious burns.
Always be aware of who and what is in the immediate and
surrounding areas of the chipper-shredder. Operators should
always work in the SAFE ZONE only.
chipping and Shredding Tips
Chipping
1. Make sure wood is less than 3 in. (7.6 cm) in diameter.
2. Make sure wood is dry.
3. Make sure all smaller branches have been pruned for the
wood.
4. Make sure pieces are long enough to be fed through the
chute.
5. Large pieces can be rotated and alternately inserted and
retracted as they are fed.
6. Always maintain control with two hands of what is being fed,
to prevent "whipping" around.
16
OPERATiON
DANGER
WARNiNG
NOTicE
Advertisement
Table of Contents
