Table of Contents
Advertisement
500137-N - 3 iN. (7.6 cM) chiPPER ShREDDER
i
Make sure the rubber blocker (C) is secure between the top
and bottom chutes. Do not operate unit if blocker is damaged
or missing.
4) install the chute Deflector
1. Align the chute deflector (B) and the hinge spacers (C) up with
the hinge mounting holes on the flailing housing. (I)
2. Slide bolt M6x100 (A) through the hinge mounting holes,
hinge spacers, and chute deflector.
3. Secure with lock nut (D). Tighten. Do not overtighten.
4. Slide knob bolt (F) through lock washer (E) and washer (G)
and then through chute deflector and lower flailing housing
assembly.
5. Tighten knob bolt. Do not overtighten.
6. Repeat for second knob bolt.
i
ii
A
B
C
D
G
E
F
WARNiNG
ii
C
B
A
E
collection bag
The collection bag can be attached and removed from the chute
deflector using the adjustable drawstring.
It is recommended to be attached before operation and removed
before completely full, after operation, or before storage. The
collection bag will collect up to 2 bushels (70 L) of material.
D
E
Before operation, ensure the adjustable drawstring is tight
around the chute deflector and secure.
When the collection bag appears to be almost full, it is
recommended to empty it. This will help to keep the bag from
becoming dislodged from the deflector chute and will also
prevent the bag from bursting. Do not allow the collection
bag to become dislodged from the deflector chute during
operation. If this occurs, stop operation at once and reconnect
the collection bag. Always empty the collection bag when the
engine is off and the spark plug has been disconnected.
Always inspect the collection bag prior to use. Do not use a
frayed, worn, or damaged collection bag.
Add Engine Oil
DO NOT attempt to crank or start the engine before it has been
properly filled with the recommended type and amount of oil.
Damage to the engine as a result of failure to follow these
instructions will void your warranty.
D
The recommended oil type is 10W-30 automotive oil.
F
1. Place the chipper-shredder on a flat, level surface.
G
2. Remove oil fill cap/dipstick to add oil.
3. Using a funnel, add up to 37.2 fl. oz. (1100 ml) of oil (not
included) and replace oil fill cap/dipstick. DO NOT OVERFILL.
4. Check engine oil level before every use and add as needed.
12
ASSEMbLY
WARNiNG
WARNiNG
NOTicE
cAUTiON
NOTicE
Advertisement
Table of Contents
