Xylem e-80SCXL Series Quick Start Manual

1 Introduction
NOTICE:
Read the installation, operation and maintenance instructions located on
the Xylem website before use. Improper use of the product can cause
personal injury and damage to property and may void the warranty. See
e-80SCXL Instruction Manual for complete Product Warranty.
WARNING:
Personal protective equipment should be worn when han‐
dling this equipment. Only use properly sized certified lift‐
ing equipment & lifting devices, including slings, suitably
rated for the weights to be lifted. Slings, when used, must
be of identical materials to avoid differences in stretch
rates. Do not use lifting devices that are frayed, kinked,
unmarked, or worn.
2 Pump Lifting
3 Assembly Parts
Series e-80SCXL
For safety and correct product usage, read the manual before this
product is used.
WARNING:
• Assembled units and their components are heavy. Failure to properly lift and support this
equipment can result in serious physical injury and/or equipment damage. Lift equipment
only at the specifically identified lifting points. Lifting devices such as eyebolts, slings,
and spreaders must be rated, selected, and used for the entire load being lifted.
• Crush hazard. The unit and the components can be heavy. Use proper lifting methods
and wear steel-toed shoes at all times.
• In order to lift the entire pump, use slings placed around the unit as shown.
1
8
2
3
4
9
WARNING:
Always disconnect and lock out power to the driver be‐
fore you perform any installation or maintenance tasks.
Failure to disconnect and lock out driver power will re‐
sult in serious physical injury.
WARNING:
This product can expose you to chemicals including
Lead, which is known to the State of California to cause
cancer and birth defects or other reproductive harm. For
more information go to: www.P65Warnings.ca.gov.
1. Motor
5
2. Motor bracket
6
7
3. Coupling
11
10
4. Coupling guard
12
5. Shaft
6. Seal assembly
QUICKSTART GUIDE
P2005592_Rev A
THE MANUAL IS AVAILABLE AT:
https://qr.xylemsales.com/i8w2sb
7. Bearing
8. Seal gland
9. Impeller
10. Impeller nut
11. Volute cover
12. Volute