Power-On Self-Test (Post) Troubleshooting; Post Operation - Quantum SDLT 600A Product Manual

Power-On Self-Test (POST) Troubleshooting

POST Operation

SDLT 600A Product Manual
There is no timeout in effect during a data transfer phase.
Note:
Following the locate operation on tape, the FTP server returns
150 Connecting to port xxx
data.
Resume is Disabled
Resume on store and retrieve operations is disabled for graphical clients,
including the built-in FTP client.
Abort Transfer
The command during a FTP transfer is not supported.
ABORT
This section provides troubleshooting information that might be helpful
should the system fail its Power-On Self-Test (POST).
See the data cartridge appendices in this document
Data Cartridges on page 119) for complete visual inspection instructions
for Super DLTtape II data cartridges.
The Web site www.dlttape.com
SDLT systems.
The SDLT 600A tape drive performs a Power-On Self-Test (POST) each
3
time the tape drive is powered on. POST normally completes in 10 to 15
seconds—when a data cartridge is not in the tape drive— when the unit is
powered on. However, if a data cartridge is in the tape drive when the
unit is powered on, POST duration is longer, depending on how much
tape in the data cartridge may be loaded in the tape drive.
Chapter 3 Using Your Tape Drive
Power-On Self-Test (POST) Troubleshooting
to the client and starts transferring
(Super DLTtape II
also includes valuable information about
3
3
3
48